British deep-sea controller DSE703
DSE703 British deep-sea is a self-starting and protection of the
engine module. It uses advanced technology surface assembly building, to provide a close, but a high degree of module specifications. Operation by the three pre-installed on the button panel, including the stop, manual and digital autopilot.
Stop mode - to stop the operation of the engine and the abolition of "automatic" mode. It may also be used in any case reset the alarm off.
Manual mode - this mode is used to staff up and running the engine, and can press the stop button to stop.
Auto mode - This option is the automatic mode operation, and the module will wait for remote start signal. Upon receipt of this signal, the module will be the beginning of it to
Set of proceedings, and in the engine to start before the delay timer to monitor the start. When the remote start signal is removed, the module will begin its shutdown procedure to be established.
This module to monitor the engine and provide the following functions:
3 times since the launch of the attempt and self-starting from the - have adjustable start and stop the timer and start the show failed.
Can be set to stop the function of heating and electricity.
Low oil pressure and high engine temperature shutdown.
Due to speeding and speed (frequency) protection.
Charge failure warning
Two auxiliary input can be set completely.
All alarms are required in high-visibility red LED display.
Microprocessor module to provide a timer can be read and function. Once in the Settings mode, you can use the button before the screen settings to adjust the parameters. Adjust the settings via the module is behind the small "switch can be set" (see Figure 1 and 2) to make adjustments, and allow for changes in the field.
Choice set model is based on the rapid flashing of the "automatic" LED lights for the show.
This module is based on deep-sea experience in design verification, and the use of modern building, in order to provide a high level of reliability and fitness for use in the desired operating environment. Publication of articles such as environmental regulations and EMC engineering standards, have joined in the design carefully. Advanced features such as protected solid-state output, means that there is no moving parts or eliminate the contact may be.
Based on microprocessor design
Automatic start and stop engine
In case the alarm automatically stops
Through the front panel settings
A simple button control to operate
Digital input can be set
Solid-state output can be set
The timer can be set numerical
Solid fuel and start-up output
Outside the remote start input
LED warning lights show
Delay start timer
Delayed stop timer
Power to stop the timer
To heat timer
May be due to speed-on-demand protection
Low oil pressure shutdown
High engine temperature shutdown
Oil-on-demand start-up can be from
DC power supply: 8 to 35 V Continuous.
Starting from: to preserve 0 V 50 ms, but to leave before the minimum power supply is 10V and the power supply back to 5V. This is not required within the cell also can achieve.
Maximum current: 50mA standby 10mA operation
Input range power ball: 75 (center line) to 277 (middle line) 3-phase 4-wire AC (+ 20%)
Electric ball input frequency: 50 - 60 Hz at rated engine speed (Minimum: 75V AC midline) (starting from the center line from the 15V)
Start output: 1.2A DC Voltage in for.
Fuel output: 1.2A DC Voltage in for.
Auxiliary outputs: 1.2A DC Voltage in for.
Size: 125 X 165 X 28 mm.
Charge of failure / excitation range: 0 V to 35 V
Operating Temperature Range: -30 to + 70 degrees
BS EN 60950 in line with the low-voltage guidelines
Comply with BS EN 50081-2 EMC guidelines
Comply with BS EN 50082-2 EMC guidelines
Contact Name: Xuesong Zhou
Company Name: Chongqing Kang Famous Commerce Co., Ltd.
Street Address: The Lettuce Groove
Industrial Park, Tongjiaqiao Street,
Martyrs Tomb Road, Shapingba Of
Member name: cqkms
Member Since: 03 February 2009
Total Leads: 52 cqkms Import Export Business Leads
Business focus: Cummins Overhaul Accessories, Assembly Parts, Filter, Crankshaft, Connecting Rod, Fuel Injection
Verify: Safe Import Export Tips